How Do I Install My Crickett®/Chipmunk® Pistol Scope Mount?

Installation Instructions:

  1. Remove the two 6×48 plug screws on the front of the receiver and the entire rear sight assembly.
  2. Place the mount base in position and start the three 6×48 screws. Do not tighten.
  3. With one hand, clamp the mount base onto the receiver. Tighten all three screws, one turn, each at a time until tight.
  4. Install and tighten any standard tip-off rings and scope of your choice.
This entry was posted in . Bookmark the permalink.

by Alicia